15
Assembly (Cont.)
Step 7: reflector assembly
Front reflector (white) and bell
1. Remove the clamp screw from the reflector (or bell) bracket (Fig. 12).
2. Push open the bracket 'loop' and slide it onto the handlebar. (If there is a sizing
insert included with the bracket, make sure it is inside the clamp loop before
mounting.)
3. Put the reflector (or bell) bracket on an appropriate position on the handlebar.
4. Tighten the clamp screw securely.
CAUTION:
Be sure the reflector is in the same longitudinal plane as the bicycle
(horizontal to the ground). If the reflector is aimed up or down, oncoming headlights
may not reflect properly in the reflector. If the reflector is not horizontal to the ground,
loosen the clamp screw and readjust the angle.
15
AFTER SALES SUPPORT
1300 886 649
AUS
MODEL: ESTC27M PRODUCT CODE: 704459 04/2021
Rear reflector (red)
1. The rear reflector is mounted on the seat post. Put the rear reflector in the
correct position by loosening the screws of the rear reflector bracket (Fig. 13).
2. Make sure the rear reflector is vertical to the ground and points straight back.
3. Make sure there are at least 3 inches (>7.5cm) of clear space between the top of
the seat and the top of the red rear reflector.
CAUTION:
It is important to check and adjust the position of the reflectors as you
assemble your bike. The reflectors must always be vertical (perpendicular to the
ground) and pointed towards the front and rear of the bike.
Fig. 12
Fig. 13
Grip
Reflector
Clamp screw
Handlebar
Reflector
bracket
(or loop)
Red
reflector
Seat post
Reflector
bracket
