IMPORTANT
Preliminary Checks:
To ensure safety and an efficiently operating automated system, make sure the following condi-
tions are observed.
The gate and post must be suitable for being automated. Check that the structure is suffi-
ciently strong and rigid, and its dimensions and weights conform to those
indicated in section 1. In particular, wheel diameter must be in relation to the weight of the
gate to be automated. Dimensions and weight must match those indicated in the technical
specifications.
Make sure the leaves move smoothly without any irregular friction during entire travel.
The soil must permit sufficient stability for the expansion plugs securing the foundation
plate.
Check if the upper guide and travel limit mechanical stops are installed.
We advise you to have any metalwork carried out before the automated system is installed.
2
Standard System
Overview and Safety
Zones
The system display to the right is a
recommended standard system. Oth-
er approved accessories can be in-
stalled. Photo sensors and a flashing
light indicating gate movement is
recommended for safety purposes.
1
Estate Swing Operator
2
Photocells (not included)
3
Key operated pushbutton (not included)
4
Flashing lamp (not included)
5
Radio receiver (optional)
Notes:
1) Do not extend operator connection cables
2) When laying electrical cables, use
appropriate rigid and/or flexible tube
3) Do not run any wires in the same conduit as
110 AC power that may be in the area. This
will cause unwanted interference
