ESP Safety UPES-50D, Operating Manual, Page: 34 / 51

34
First set the sensor type for the sensor, then press the ("Prog") button and switch to setting the
sensor MODBUS address.
The numbering of the sensors is similar to the numbering when searching by address and type
from 1 to 8 in the "two port" mode, and with 1 to 16 in all other modes. Setting the necessary
number of sensors, press the ("Prog") button until the menu appears.
The search program is started in the same way.
When the search is complete, the display will display the number of sensors found and the two-
channel board will switch to the state and measured parameters control mode for the sensor.
If the number and types of sensors found are satisfactory for the user, exit the menu by pressing
the ("Control/Exit") button. UPES will switch to standby mode.