ESP Safety UPES-50D, Operating Manual, Page: 26 / 51

26
Channel Settings Copy Menu
In UPES, it is possible to copy settings of the sets of channels. To do this, select the (Copy
channel x) (Fig T7).
Figure T7
In this menu it is possible to copy the settings of the first or second channel x sets in any other
set and channel from the system. Press the ("Prog") button in the (Channel copy) menu and
use the " + "or "-" buttons to select which of the sets you want to copy and press the
(Test/Enter) button.
Then press the ("Prog") button and you will enter the set selection menu where to copy the
settings. Use the "+" or "-"buttons to select the desired channel and the desired set and press
the (Test/Enter) button. Once the data have been copied to the channel board, the central
processor controller will automatically revert to the beginning of the menu (Copy Channel x).
When copying the following channel parameters are copied to the copied channel:
1) Activation of the channel "on/off";
2) Relay first and second threshold status NO/NC ("Relay 1", "Relay 2");
3) Relay delay time.