ESP Safety UPES-50D, Operating Manual, Page: 22 / 51

22
Channel programming menu
To set the parameters for the channel board select the desired channel board with the "+" and
"-" buttons and press the ("Prog") button.
When you enter the main menu ("Programming x Channel"), where x is the number of the
selected channel, press again the ("Prog") button, then you get into the channel board setup
menu (fig. T3)
Figure T3
In the channel board there are two sets of relays — 1 and 2 of the threshold. When
connecting the channel board with the sensors in the two independent ports mode, the first
set of relays is linked to the sensors connected to the first port, the second set of relays is
linked to the sensors connected to the second port. In all other operating modes, the first