ESP Safety UPES-50D, Operating Manual, Page: 29 / 51

29
Search for Sensors by Address
The sensors in the channel board can be searched for by the known address. To do this,
use the "+" and "−" buttons to select the (Channel x search by address) menu item (fig. T10) and
press the ("Prog") button.
Figure T10
In the sensor address setting menu the top line contains the number of the channel board, in
which the search for the sensor will be performed, and the ordinal number of the sensor. If the
channel board is set to the operation mode with two independent ports, the numbering of the
sensors will be not from 1 to 16 but from 1 up to 8 with indication of the port number to which
the sensor is connected, i.e. the top line will look like this ("Channel x-1 P1"), where P1 means
that the sensor is connected to the first port.