Type / N.
Rev.
Data
Page
Total pages
EW095.605
5
November 2010
80
96
EsiWelma
s.r.l.
The keypad has the following commands:
Arrows to scroll up and down the screen
<enter> Move from the screen to the next level of information
<reset/escape> Return to previous page. If in setting, it must be pressed for 5
seconds to return to the previous page and memorize any parameters that
have been changed
If pressed at the same time for at least 5 sec. they take the control unit to
setting status and the relative cursor appears on the display. In setting, they
are used to decrease/increase or offer alternatives to the data inserted in the
box to the right of the cursor
Cursor that appears in "setting" status
Indicates that there is more information above the window displayed
Pointer
Indicates that there is more information below the window displayed
Table 11.1 – Keypad of the UCE40... control unit
11.2 Field devices
All field devices are fitted with a power supply input of 11
÷
14Vdc, and a BUS communication
connection line.
They are internally fitted with a configuration button and a status LED that can show three
display statuses
•
Rapid flashing (1 Hz): field device to configure
•
Slow flashing: configured field device (lamp flash every 10 sec.)
•
Steady on: sensor in alarm condition (PR, 1t, 2t exceeded or FA)
The LED can be forced to "steady on" by setting up the control unit (forced or FA of the
sensor status); this allows the operator to visually identify the configured field device.
