Type / N.
Rev.
Data
Page
Total pages
EW095.605
5
November 2010
17
96
EsiWelma
s.r.l.
3.3.2
Flush panel mounting
Mount as follows:
1. prepare a piece of DIN rail no shorter than 160 mm with holes on the side to pass
through dedicated tie rods (Fig. 3.12)
2. knock out a 46x106 mm opening on the front panel of the electric board and drill two
holes on the sides for the tie-rods to pass through (line them up with the DIN rail
holes (Fig. 3.13)
3. fit the module on to the DIN rail as shown in Par. 3.3.1
4. Use the dedicated tie rods to fix the whole thing to the panel (Fig. 3.14).
Fig. 3.12 – Preparing the DIN rail
Fig. 3.13 – Preparing the panel
Fig. 3.14 – Fixing the module to the panel
106
4
6
106
4
6
