6.7 Assign MIDI Program Change Messages to Encoders
To assign Program Change messages to an encoder:
•
Press the EDIT button to enter EDIT mode. The EDIT button (RED) and all the pads
(GREEN) will flicker.
•
Select one of the three CTRL BANKS (GREEN YELLOW, RED) by pressing CTRL
BANK once or several times.
•
Select and rotate the encoder that you would like to edit.
•
Press the TYPE button next to the EDIT button until it turns RED, indicating that
you are assigning Program Change messages to this encoder.
•
Press Pad 16 to confirm and exit SETUP mode. The selected encoder now
gradually changes the program numbers by turning the knob.
•
Pad 16 will flash GREEN two times to confirm that the input was correct and has
been saved.
6.8 Assign Channel Pressure Messages to Encoders
To assign Channel Pressure messages to an encoder:
•
Press the EDIT button to enter EDIT mode. The EDIT button (RED) and all the pads
(GREEN) will flicker.
•
Select one of the three CTRL BANKS (GREEN YELLOW, RED) by pressing CTRL
BANK once or several times.
•
Select and rotate the encoder that you would like to edit.
•
Press the TYPE button next to the EDIT button until it appears unlit (dark),
indicating that you are assigning CHANNEL AFTERTOUCH messages to this
encoder.
•
Press pad16 to confirm and exit SETUP mode. Again Pad 16 will flash GREEN two
times to confirm that the input was correct and has been saved.
Page of
31
37
Summary of Contents for Artesia Pro XJam
Page 1: ...MIDI Performance Controller USER GUIDE...
Page 2: ......
Page 40: ...Manual Version 1 0...
