6.5 Assign CC Messages to Encoder Knobs
To assign a Control Change messages to an encoder:
•
Press the EDIT button to enter EDIT mode. The EDIT button (RED) and all the pads
(GREEN) will flicker.
•
Select one of the three CTRL BANKS (GREEN YELLOW, RED) by pressing CTRL
BANK once or several times.
•
Select and rotate the encoder that you would like to edit.
•
Press the TYPE button next to the EDIT button until it turns GREEN, indicating
that you are assigning CC data to this encoder.
•
The pads with the number keys 1 to 10 as well as pads 16 (ENTER) will illuminate
RED and become optional.
•
Compose the MIDI Control Change number using the 1-10 pads (10 means 0). At
each press the pads will turn YELLOW.
•
Press Pad 16 to confirm and exit SETUP mode.
•
Pad 16 will flash GREEN two times to confirm that the input was correct and has
been saved.
6.6 Assign Pitch Messages to Encoder Knobs
To assign Pitch data to an encoder:
•
Press the EDIT button to enter EDIT mode. The EDIT button (RED) and all the pads
(GREEN) will flicker.
•
Select one of the three CTRL BANKS (GREEN YELLOW, RED) by pressing CTRL
BANK once or several times.
•
Select and rotate the encoder that you would like to edit.
•
Press the TYPE button next to the EDIT button until it turns YELLOW, indicating
that you are assigning Pitch data to this encoder.
•
Press Pad 16 to confirm and exit SETUP mode.
•
Pad 16 will flash GREEN two times to confirm that the input was correct and has
been saved.
Page of
30
37
Summary of Contents for Artesia Pro XJam
Page 1: ...MIDI Performance Controller USER GUIDE...
Page 2: ......
Page 40: ...Manual Version 1 0...
