•
Press the pad that you would like to edit.
•
Press the TYPE button next to the EDIT button until it turns YELLOW, indicating
you are assigning CC data to this pad.
•
The pads with the number keys 1 to 10 as well as the pads 15 and 16 (ENTER) will
illuminate RED and become optional.
Note:
Within the next EDIT step again, you’re about to execute
two
operations at
once:
First
, you will select the transmission mode, ABSOLUTE or RELATIVE, refer to
4.1.2 Sending Control Changes.
Second
, you are going to select the MIDI Control
Change message as referred to below.
•
Press either Pad 1 (ABSOLUTE) or Pad 2 (RELATIVE) to enter the transmission
mode. The selected pad will turn YELLOW after pressing it.
•
For further description of the two transmission modes, please refer to this chapter:
•
In the above picture the ABSOLUTE transmission mode is selected
•
Press Pad15 to confirm your selection.
•
Compose the MIDI Control Change number using the 1 - 10 pads (10 means 0). At
each press the pads will turn YELLOW.
•
Press Pad 16 to confirm and exit EDIT mode.
•
Pad 16 will flash GREEN two times to confirm that the input was correct and has
been saved.
Page of
26
37
Summary of Contents for Artesia Pro XJam
Page 1: ...MIDI Performance Controller USER GUIDE...
Page 2: ......
Page 40: ...Manual Version 1 0...
