7
5. Inflation and Deflation
1.
Press (P1) or (P2) to select default
preset
pressure.
2.
Press (+) or (-) to adjust target pressure.
3.
Connect with t
i
re, ensure no air leaks,
inflator will start automatically.
4.
When inflation is finished, the device will
stop automatically and BEEP to remind
the user.
5.
Disconnect the air hose from t
i
re.
6.
Power on/Power off/Backlight
When battery indicator is flashing on the
LCD screen please recharge the battery.
Press (ON/OFF/LIGHT) two seconds to
turn on.
Press (ON/OFF/LIGHT) to turn on backlight
when the device is on.
Press (ON/OFF/LIGHT) for three seconds
to turn off.
Notes:
1.
Press (SET) to enter the function setting
mode. After selecting the unit, press
(SET) again to enter the (OPS) setting.
2.
Press (SET) four times and the device
will
exit out of the setting mode without
saving any selection.
3.
When OPS function is selected the
device will inflate to target pressure plus
the OPS value first, then deflate to t
i
re
pressure desired, for example: A final
target of 32 psi or 2.2 bar with an OPS
setting of 16 psi or 1.1 bar gives a sum
of
48 psi or 3.3 bar. This sum of 48 psi or
3.3 bar is the Over Pressure Setting for
t
i
re. The t
i
re will inflate to the sum value
and deflate to the final target pressure.
4. During inflation, the device will check
t
i
re pressure automatically, the working
indicator will be on, left to right means
inflating, right to left means deflating.
To avoid the risk of
personal injury, especially
to the eyes, face or skin.
DO NOT direct the air
stream at any person
WARNING
This equipment is not
intended for use by
children without adult
supervision
WARNING
When using the OPS
function the sum pressure
must not exceed the tyre
manufacturer’s maximum
inflation pressure.
WARNING
