630288_0_Manual_Installation-Service_ST900_AUS NZ
28
18.2
Assembling the Velo fascia:
Preparation:
1.
The supplied upper baffle must be removed
and discarded before continuing with the
install. To do so, undo the 4x screws shown
right and remove the baffle by lifting it
upwards and outwards as shown.
2.
Install the Heat Deflector to the top of the fireplace using the 3x supplied screws with
the
Heat
Deflector
facing
outwards as shown.
3.
Install the supplied Upper Baffle (the part with grill fitted) into the fireplace with grills
facing downwards. Fix in place using the 4x supplied screws in the position shown.
4.
Install the lower fascia magnet brackets using the 4x supplied screws in the two
positions shown below. (Do not affix the magnets at this stage)
Installation:
5.
The ST900 fascia uses the hooks on the rear
for attaching to the fire. Line up the hooks
with the receptacles on the sides of the
fireplace,
and
lift
the
fascia so that the hooks
are above the receptacles. Let it drop down
into position until it is secure and free from
movement. The Heat Deflector (2) should sit slightly inside the fascia so that the
fascia can sit tight against the wall.
