630288_0_Manual_Installation-Service_ST900_AUS NZ
11
9.1
If you are using a battery pack:
Using a battery pack will allow your ST900 to operate without mains power, allowing the fire
to run in the event of a power cut. This battery pack uses 3x C cell batteries.
To install the battery pack simply place
the pack in the bottom right of the fire
as pictured below and connect it to the
plug which should be near the brass
Copreci valve.
To access the battery pack, remove
the
fascia
(described
in
section
18)
and the battery pack will be on the
lower right hand side.
As the ST900 draws a small current when not in use, it is recommended to remove the
batteries if the fire will not be in use for long periods of time.
10.0
Fixing the Fire to the base and wall:
It is a requirement that this fire be securely
fastened to the wall and base. Once the fire
has been pushed back into the correct
position, use wood screws (or other suitable
fasteners) to fix the fire to the cavity through
each of the four holes in the corners, as
shown in the diagram to the right.
Note: It
may be necessary to use washers on the
fasteners to securely fasten the fire to the
wall.
When fixing the fireplace in position ensure
that you leave a gap between the fireplace
flange and the framing timber for the wall
lining, which will be added at a later stage.
11.0
Removing the Firebox Glass:
Pull the four hooks shown below towards you and then away from the glass to release the
glass frame underneath the hook.
Do not operate the appliance if the glass has been broken, damaged, or the glass is
not properly positioned/hooked onto the appliance.
