ERL F-PRO 5100, User Manual

Page: 18 / 192

2 Setup and Communications
2-4 F-PRO 5100 User Manual D02416R04.00
Modem Link -
Internal
Desktop Computer
Analog
Telephone
Line
Port 5 - RJ-11 modem
Telephone
System
Analog
Telephone
Line
F-PRO
Feeder Protection
Model 5100
Port 1
Date &
Time
View
Readings
View
Logs Prev Next
Target
Clear
Target
1999 JUN 07
Relay Functional
IRIG-B Functional
Service Required
Test Mode
Alarm
Figure 2.3: Internal Modem Link
The relay’s user interface can also be accessed through a telephone link be-
tween the relay and your computer using an optional internal modem. If the
modem has been installed, Port 5 on the rear panel will be labelled “INTER-
NAL MODEM.”
Connect the relay’s Port 5 to an analog telephone line or switch using a stan-
dard RJ-11 connector.
When an internal modem is installed, the relay’s Port 2 is used to interface to
the modem internally. Appropriate Port 2 settings are configured at the factory
when the internal modem is installed. The factory defaults are: “M0S0=0&B1”
for an external modem and “M0S0=0” for an internal modem.
Network Link
PC with TCP/IP
Port 5 - RJ-45
Network
10BaseT
TCP/IP
Network
F-PRO
Feeder Protection
Model 5100
Port 1
Date &
Time
View
Readings
View
Logs Prev Next
Target
Clear
Target
1999 JUN 07
Relay Functional
IRIG-B Functional
Service Required
Test Mode
Alarm
Figure 2.4: Network Link
You can access both the relay’s user interface and DNP3 SCADA services si-
multaneously through the same network port with an optional Ethernet TCP/IP
LAN link. If the Ethernet option has been installed, Port 5 on the rear panel will
be labelled “NETWORK.”
The user interface accessed through the LAN is the same as that available
through a direct serial connection or a modem link, but requires the use of a
Telnet client on your PC. The HyperTerminal program, which is included in
Windows XP and is also available separately as HyperTerminal PE, provides
Telnet services. To select Telnet, go to HyperTerminal’s Properties dialog box
and set the
Connect Using field to TCP/IP (Winsock) . If this option is not avail-