ERL F-PRO 5100, User Manual

Page: 97 / 192

D02416R04.00 F-PRO 5100 User Manual 7-1
7 Installation
Physical Mounting
Standard 3U The relay is 3 rack units or 5.25 inches high and approximately 12.25 inches
deep. The standard relay is designed for a 19-inch rack. A complete mechani-
cal drawing is shown, for details see “Mechanical Drawings” in Appendix G.
To install the relay you need the following:
• 19 inch rack
• 4 - #10 screws
AC and DC Wiring
For details see “AC Schematic Drawing” in Appendix I and “DC Schematic
Drawing” in Appendix J.
Communication Wiring
EIA-232 All of the relay’s serial ports (Ports 1, 2 and 3) are configured as EIA RS-232
Data Communications Equipment (DCE) devices with female DB9 connec-
tors. This allows them to be connected directly to a PC serial port with a stan-
dard straight-through male-to-female serial cable for pin-out, for details see
“Communication Port Details” on page 2-9.
Ethernet/Modem The relay has an RJ-45 receptacle for accepting a 10BaseT Ethernet connector
or an RJ-11 connector.
IRIG-B Wiring The IRIG-B connector on the back of the relay is BNC type.