Command Line Interface
2.11
Management Configuration Mode
2.11.1 Overview
A management entity is an entry point for management in the EXN400. It is
uniquely identified by an IP address. One management entity should be
configured to:
Perform an FTP connection
•
•
•
Enable a telnet access to the EXN400
Enable SNMP management.
To fully configure a management entry point, you should first create a
management entity and then bind a PVC or Ethernet interface to this
management entity. A bridge can also be bound to a management entity to
allow management through any interface bound to the bridge.
In this release up to 8 management entities can be created.
2.11.2 Entering
Mode
To create or modify a management entity, from the Global Configuration
mode, enter the following command:
management management_name
where:
management_name
Specifies the name of the management entity.
It can be up to 15 alphanumeric characters long.
Only one PVC or Ethernet interface can be bound to a management entity.
The next prompt is
config-mngt
.
Any change in this mode is not applied in real time but only when leaving
the current mode by running the
exit
command or explicitly requesting
change by running the
apply
command. However, the current mode can
be exited without saving by running the
abort
command.
64
1553-LZY 214 2655 C 2004-11-24
