Operating Instruction
Spindle lifting system SL/SM compact
Document no.: B-00061
Edition 2018 02
operating instruction EN
Copyright by Ergoswiss AG
14/23
5.5
Setting the shown height on the display
(Only with manual control switch type Memory!)
The displayed height can be adjusted with this feature.
1.
Drive to any desired height and press the button
S
(Save).
Display:
2.
Keep the button
impressed for about 5 seconds, until the display starts flashing.
Example:
3.
Now the button
(plus) or
(minus) can be used to set the current height.
While doing so, the system does not move!
4.
With the correctly set value the new height is saved by pressing
S
(Save).
5.6
Container-Stop and Shelf-Stop-positions
These two features can be used to limit the movement area of the desktop (e.g. if a container is placed un-
derneath the desktop). A container stop position can be defined in the lower half of the movement area, a
shelf stop position in the upper half. If a container stop position is set, this position will be the lower limit
position. If a shelf stop position is set, this position will be the new upper limit position.
To store a container stop / shelf stop position, go on as shown below:
1.
Move the desktop to the position where the container stop / shelf stop should be stored.
2.
Keep
and
pressed at the same time for 10 s.
Control box will
click twice
when position is stored.
To deactivate the container stop / shelf stop position go on as shown below:
3.
Move the desktop to any position in the lower or upper half to deactivate the container stop / shelf
stop.
4.
Keep
and
pressed at the same time for 10 s.
Control box will
click twice
when stored position is deactivated.
NOTE
These steps have to be done for a container stop and a shelf stop position separately.
