Operating Instruction
Spindle lifting system SL/SM compact
Document no.: B-00061
Edition 2018 02
operating instruction EN
Copyright by Ergoswiss AG
15/23
5.7
Reset of the control box
5.7.1
Redefine end positions
1.
Drive the system to the lowest position.
2.
Press
for 5 s («Long Key Down»).
System will drive to the block position and adjust itself back to its lower position.
5.7.2
Reset control box to factory settings («S 0»)
(Only with manual control switch type Memory!)
1.
Press the buttons
1
,
2
and
simultaneously, until
“S 5“ or “S 7“ is displayed.
2.
Press the button
until
“
S 0
“ appears
on the display.
3.
Press the button
S
(Save).
Control box clicks 3 times and the display shows «E70»!
4.
Disconnect power cable and wait for at least 5 seconds.
5.
Connect the power cable.
The display is flashing «000»!
6.
Press
für 5 s («Long Key Down»).
The system moves downwards at half speed until the block position is reached.
NOTE
While commissioning (“Long Key Down”) the control box works with only half power and half
speed. The system should be fully loaded after finishing the initial operation.
