ergoline ergoselect 4, Operator'S Manual

Page: 57 / 96

9 Control Terminal T
ergoselect 4 / 5 55
After pressing the [ Training/Test ] key in the main menu,
you will see the defined Training/Test protocols.
Training/Test
You can choose from 20 different protocols:
• Pulse • Ramp test
• Constant • PWC Test 1
• Interval • PWC Test 2
• Interval HR • PWC Test 3
• Countdown
Select the desired protocol by pressing the appropriate key.
Pulse
Constant
Interval
Interval HR
Countdown
Ramptest
PWC Test 1
PWC Test 2
PWC Test 3
Interval 1
Figure 9 – 23: Selecting the training/test protocol
With the [ Edit ] key, you enter the first input level of the
protocol.
At Heart Rate you can select the available sources of the
heart rate signal.
Options are:
• HR belt (requires selection of the HR belt ID)
• ECG (suction system On/Off – if available)
• Polar
Note
Make sure that the selected belt ID is the ID of the
belt actually used on the patient.
Further editing options depend on the selected protocol
type; they are described in detail for each test and training
protocol below.
Description
Heart Rate
Pump
Pulse
Basic Load: 20 W
Slope: 25 W/min
Recovery: 3 min Load: 20 W
ECG
I/O
Edit
Saddle
Figure 9 – 24: Training/test – editing protocol parameters
With the [ Edit ] key, you always enter the first input level
of the protocol.
If a protocol type has more than one input levels, you return
to the previous level
2.
and advance to the next level
2.
with the appropriate number key.
If you need to input characters (numbers or letters), an
(alpha-) numeric keypad or a keyboard will be displayed.
Inputs are confirmed with the [ ] key.
The following sections describe each protocol type in detail.
2.
Description Pulse
Type Pulse
Warm-Up Load 20 W
Warm-Up Time 2 min
Figure 9 – 25: Changing the input level