MT CAM AG_v1.doc
MT STAR AG
Indice : 1
18/10/2016
18 /
25
ERECA SAS 75 rue d'Orgemont, 95210 SAINT GRATIEN France
Tel +33 1 39 89 76 23 www.ereca.fr
2.7.2 SEPARATE INTERCOMS
Talk command sources are:
•
Camera unit button (enable talk on Intercom1/channel1 and/or Intercom2/channel2),
•
Serial 1 RJ45 ground closure (enable talk on Intercom1/channel1),
•
Ground closure on the Hirose 12 connector (enable talk on Intercom2/channel2).
By default or when talking on Intercom1, the blue button rotation will adjust global listening level of the audio
mix programmed on intercom1.
When talking on Intercom2 rotating the blue button will adjust global listening level of the audio mix
programmed on intercom2.
3
WEB MANAGEMENT
Full control and setup of the Cam racer transmission can be done trough the web server. As described in
the previous sections some settings can be done directly on the units by the “blue” button, in this case the
buttons settings will take precedence on the web page control. When adjusting volume with the button the
corresponding fader will move on the webpage but is no more responsive to any change attempt made on
the web page for a small amount of time (1 second).
3.1 ESSENTIALS
The CAM RACER is monitored and configured through WEB interface. (Firefox web browser preferred).
The RJ45 Ethernet ADMIN port of the basestation provides access to the embedded web server interface.
Note this network have no relation with the remote camera remote Ethernet port.
The default web server interface IP add is 192.168.1.247.
A long press (5 seconds) on the
Reset
at the left of the admin Ethernet port will reset its configuration and
revert the default IP add.
The home page displays Red Tabs on it is upper part, giving access the different parts of the supervision:
•
Status – Alarms:
Provides the status of the signals and the alarm report of the product.
•
Measures:
Provides the details of the technical information of the product.
•
Settings:
To set Internal audio mixer, MIC input gains, Intercom modes….
•
Configuration:
To configure the IP address of the product and supervision settings.
Camera head unit have no internal web server, the whole link is monitored trough the basestation web
server. The basestation hold all the configuration, and updates the camera head module once the link is
established.
