ERBAUER 457MM SCROLL SAW ERB704SSW
INTERIOR CUTTING (Fig. 16)
- Lay out the design on the workpiece. Drill a 1/4"
(0.6 cm) hole in the workpiece.
- Remove the blade. Refer to the section “Blade
removal and Installation.”
- Place the workpiece on the work table with the
hole in the workpiece over the access hole in the
work table.
- Install a blade through the hole in the workpiece.
- Follow steps 3-7, under “Freehand cutting”.
- When finished making the interior scroll cuts,
simply turn the scroll saw OFF.
Unplug the saw before removing the blade from
the blade holder. Remove the workpiece from the
table.
BEVEL CUTTING (ANGLE CUTTING) (Fig. 17-18)
- Lay out or secure design to workpiece.
- Move the drop foot to the highest position by
loosening the drop foot lock knob. Retighten the
drop foot lock knob.
- Tilt the table to the desired angle by loosening
the bevel locking lever (7) turn bevel adjusting
knob (35) to move the working table to the proper
angle using the bevel scale (14) and the bevel
indicator (5).
- Tighten the bevel locking lever (7).
- Loosen the screw (33) with 5 mm hex key, and tilt
the drop foot (16) to the same angle as the working
table. Retighten the screw.
- Position the workpiece on the right side of the
blade. Lower the drop foot against the surface
by loosening the drop foot lock knob. Retighten
the drop foot lock knob.
- Follow steps 5-7 under “Freehand cutting”.
14
7
35
Fig. 16
Fig. 17
33
16
Fig. 18
