ERBAUER 457MM SCROLL SAW ERB704SSW
ON/OFF SWITCH AND VARIABLE SPEED
KNOB (Fig. 13)
- To turn the saw ON, press the green button “I”
(39).
- To turn the saw OFF, press the red button “O”
(40).
NOTE:
After saw is turned on, a hesitation
before blade movement is normal. Always
wait for the saw to come to a complete stop before
restarting.
WARNING:
To prevent serious personal
injury, never leave the saw unattended until
the blade has come to a complete stop.
You scroll saw has a variable speed knob (19). By
turning the knob, the variable speed control may
be adjusted from the high speed of approximately
1600 RPM to the low speed of approximately 400
RPM. Suggested speeds are referred to the section
“Blade Selection.”
- Turn the variable speed knob (19) to adjust the
blade speed to the desired setting. Turning the
knob clockwise increases speed. Turning it
counterclockwise reduces speed.
LED LIGHT SWITCH (Fig. 14)
- To turn the light on, press the LED light switch (2)
to the ON (I) position.
- To turn the light off, press the LED light switch (2)
to the OFF (O) position.
FREEHAND CUTTING (Fig. 15)
- Lay out desired design, or secure design to the
workpiece.
- Raise the drop foot (16) by loosening the drop
foot lock knob (25).
- Position the workpiece against the blade and
place the drop foot against the top surface of the
workpiece.
- Secure the drop foot (16) by tightening the drop
foot knob knob (25).
- Remove the workpiece from the blade prior to
turning the scroll saw ON.
CAUTION:
In order to avoid uncontrollable
lifting of the workpiece and to reduce blade
40
2
39
25
16
19
Fig. 13
Fig. 14
