ERBAUER 457MM SCROLL SAW ERB704SSW
MOUNTING SCROLL SAW TO WORKBENCH
(Fig. 1)
If the scroll saw is to be used in a permanent
application, we recommend that you secure it in a
permanent location such as a workbench. When
mounting the saw to a workbench, holes should
be drilled through the supporting surface of the
workbench.
- Insert one rubber foot (12) into each hole of the
base on the scroll saw assembly (27).
- Each hole in the base of the saw should be bolted
securely using hex bolts (29), locking washers (30)
and hex nuts (31) (not included). Bolts should be
of sufficient length to accommodate the saw base,
washers, nuts and the thickness of the workbench
(32).
WARNING!
To avoid serious personal injury
from unexpected tool movement, always
secrurely mount scroll saw to a workbench.
NOTE:
All bolts should be inserted from the
top. Install the washers and nuts from the
underside of the bench.
- Place scroll saw on workbench. Using the saw
base as a pattern, locate and mark the holes where
the scroll saw is to be mounted.
- Drill four holes through the workbench.
- Place scroll saw on workbench, aligning holes in
the saw base with the holes drilled in the
workbench.
- Insert all four bolts and tighten securely with
washers and nuts.
Supporting surface where scroll saw is mounted
should be examined carefully after mounting to
insure that no movement during use can result. If
any tipping or walking is noted, secure workbench
or supporting surface before beginning cutting
operations.
WARNING!
Do not connect to power supply
until assembly is complete. Failure to comply
could result in accidental starting and possible
serious injury.
Fig. 1
27
29
12
30
31
32
