ERBAUER 457MM SCROLL SAW ERB704SSW
SQUARING THE WORKING TABLE TO THE
BLADE (Fig. 5-7)
- Open the blade guard (18) upward.
- Loosen the screw (33) and remove the drop foot
(16).
- Loosen the bevel locking lever (7) to tilt the working
table by turning the bevel adjustment knob (35)
until it is approximately perpendicular or at right
angle to the blade.
- Place a combination square (36) on the working
table (23) next to the saw blade (8).
- Loosen the screw (37) holding the bevel indicator
(5). Move indicator to the 0° mark and securely
tighten screw. Remember, the bevel scale (14)
is a convenient guide but should not be relied
upon for precision. Make practice cuts on scrap
material to determine if your angle settings are
correct.
- Replace the drop foot and tighten the screw (33).
- Close the blade guard (18).
NOTE:
When cutting at angles, the drop foot
should be tilted so it is parallel to the working
table and rests flat against the workpiece.
Fig. 5
16
33
18
Fig. 6
5
35
14
37
7
Fig. 7
8
23
36
