27
NOTE:
Keep the product moving at all times, do not stop in one position
to avoid high temperature.
02
Direction of feeding (Fig. I and J)
• Always route against the rotation direction of the router bit. Otherwise the router bit
will become loose in the collet (Fig. I).
• Move the product anticlockwise when routing on workpiece edges, move the
product clockwise when routing the inside of the workpiece (Fig. J).
NOTE:
For satisfactory results we recommend always using the guides
provided.
03
Parallel cuts and edging
Parallel cuts and edging shall use the parallel guide assembly provided.
1. Attach the parallel guide assembly (14) to the product.
2. Place the product on the workpiece with the parallel guide assembly (14) laying
against the workpiece edge and adjust it to the desired width.
3. Set the cutting depth carefully and start to work.
04
Template cuts (Fig. K)
1. Attach the suitable template guide (16) to the product.
2. Lay the template onto the workpiece and fix it using proper clamps. Fix the clamps
in a way that they will not block the movement of the product.
3. Place the product on the workpiece with the collar of the template guide (16) lying
against the template edge.
4. Apply light pressure against the template during operation to ensure the template
guide lies flat against the template edge.
After use
• Switch the product off, wait for complete stop, disconnect it from the power supply,
let it cool down and remove the router bit.
• Check, clean and store the product as described below.
710W router MNL_EPR710_TPS_GB_V1_V10518_20180606.indd 27
6/6/18 8:40 AM
Summary of Contents for 3663602796282
Page 6: ...6 G 3 1 2 4 H I J K 710W router MNL_EPR710_TPS_GB_V1_V10518_20180606 indd 6 6 6 18 8 40 AM ...
Page 34: ......
Page 35: ......
