24
Use
Intended use
This product is intended for routing grooves, edges, profiles and elongated hole cuts
in wood, plastic and light building materials, while resting firmly on the workpiece. The
product must be used in an upright position.
Never use for working overhead or on vertical surfaces.
Before you start
01
Protection
Controls
01
On/off switch (Fig. E)
1. Push on/off switch (2) to left to switch the product on.
2. Push on/off switch (2) to right to switch the product off.
02
Speed dial (Fig. F)
Adjust the maximum speed by using the speed dial (3).
1. Turn the speed dial (3) to larger number to increase the speed. A higher setting
is suitable when using large diameter router bits or working on hard materials like
wood.
2. Turn the speed dial (3) to smaller number to decrease the speed. A lower setting
is suitable when using small diameter router bits or working on soft materials like
plastic.
710W router MNL_EPR710_TPS_GB_V1_V10518_20180606.indd 24
6/6/18 8:40 AM
Summary of Contents for 3663602796282
Page 6: ...6 G 3 1 2 4 H I J K 710W router MNL_EPR710_TPS_GB_V1_V10518_20180606 indd 6 6 6 18 8 40 AM ...
Page 34: ......
Page 35: ......
