Commands 5-27
• The print starting position moves from the current position to [
N
✕
horizontal or vertical motion unit]
• The horizontal and vertical motion unit are specified by GS P.
• The GS P command can change the horizontal (and vertical)
motion unit. However, the value cannot be less than the minimum
horizontal movement amount, and it must be in even units of the
minimum horizontal movement amount.
• In standard mode, the horizontal motion unit is used.
• In page mode, the horizontal or vertical motion unit differs as
follows, depending on the starting point of the printing area:
➀
When the starting position is set to the upper left or lower right
of the printable area using ESC T, the horizontal motion unit (x)
is used.
➁
When the starting position is set to the upper right or lower left
of the printable area using ESC T, the vertical motion unit (y) is
used.
[Reference]
ESC $
, GS P
ESC a
n
[Name]
Select justification
[Format]
ASCII
ESC
a
n
Hex
1B
61
n
Decimal
27
97
n
[Range]
0
≤
n
≤
2, 48
≤
n
≤
50
[Description] Aligns all the data in one line to the specified position.
n selects the type of justification as follows:
[Notes]
• The command is enabled only when input at the beginning of the
line.
• If this command is input in page mode, the printer performs only
internal flag operation.
• This command does not affect printing in page mode.
• Lines are justifiedwithin the specified printing area.
• Spaces set by HT, ESC $, and ESC \ are all justified.
[Default]
n = 0
[Example]
n
Justification
0, 48
Left justification
1,49
Centering
2, 50
Right justification
Summary of Contents for TM-T85
