Epson TM-T85, Operator'S Manual

Page: 63 / 115

Commands 5-5
Bit 5: Becomes on when printing stops due to paper-end detected by the
paper roll end sensor or due to a paper near-end enabled by using
the ESC c 4.
n = 3: Error status
Bit 3: If these errors occur due to paper jams or the like, it is possible to
recover by correcting the cause of the error and executing DLE ENQ
n
(1
≤
n
≤
2). If an error due to a circuit failure (e.g. wire break)
occurs, it is impossible to recover.
Bit 6: When printing is stopped due to high print head temperature, bit 6 is
On until the print head temperature drops sufficiently.
n = 4: Continuous paper sensor status
6
Off 00 0 No error.
On 40 64 Error occurs.
7 Off 00 0 Not used. Fixed to Off.
Bit Off/On Hex Decimal Function
0 Off 00 0 Not used. Fixed to Off.
1 On 02 2 Not used.Fixed to On.
2 - - - Undefined.
3
Off 00 0 No auto-cutter error.
On 08 8 Auto-cutter error occurs.
4 On 10 16 Not used. Fixed to On.
5
Off 00 0 No unrecoverable error.
On 20 32 Unrecoverable error occurs.
6
Off 00 0 No auto-recoverable error.
On 40 64 Auto recoverable error occurs.
7 Off 00 0 Not used. Fixed to Off.
Bit Off/On Hex Decimal Function
0 Off 00 0 Not used. Fixed to Off.
1 On 02 2 Not used. Fixed to On.
2 Off 00 0 Paper roll near-end sensor. Paper adequate.
Bit Off/On Hex Decimal Function