Epson TM-300A, Operator'S Manual

Page: 48 / 75

ESC i
[Name] Execute full-cut
[Format] <1B>H<69>H
[Description] Executes a full-cut of the paper.
[Note]
l
Valid only when input at the beginning of a line.
ESC m
[Name]
Execute partial-cut
[Format] <1B>H<6D>H
[Description] Executes a partial-cut of the paper.
[Note]
l
Valid only when input at the beginning of a line.
ESC p m n1 n2
[Name]
[Format]
[Range]
[Description]
[Notes]
[Default]
[Reference]
Generate drawer kick-out drive pulse
<1B>H<70>H<m><n1><n2>
0 m 1
0< n1 n2 255
The pulse set by
n1
and
n2
is output to the connector pin m.
l
The value of m is used as follows:
m
Connector pin
0
Drawer kick-out connector pin 2
1 Drawer kick-out connector pin 5
l
The circuit on the user side should be designed so that the
drawer drive duty will be as shown below.
ON time
0 . 2
ON time + OFF time
ON time is
n1 X 2
ms, and OFF time is
n2 X 2
ms.
It is recommended that
n2
be four times as much as
n 1.
l
The resistance of the drawer kick-out solenoid shall be 24
or more. Otherwise, the overcurrent will flow.
l
Be sure to use the printer power supply (pin
4)
for the drawer
power source.
Neither m,
n1,
nor n2 is defined.
APPENDIX B Connectors and APPENDIX E Notes on Using
the Drawer Kick-out Connector.
4 2