103
About Ink and Chip Unit Replacement
When the message
Check Ink Levels
is displayed on the LCD screen, you need to refill the ink and
replace the chip unit soon. Obtain an ink pack of the appropriate color as soon as possible.
You will be unable to print if a chip unit needs to be replaced. If the
Check Ink Levels
message is
displayed during a print job, the print job pauses while you refill the ink and replace the chip unit. You can
use the same procedure to refill the ink and replace chip units for all colors.
Note:
When the message
Refill Ink Tank
is displayed on the LCD screen and the remaining ink level is
greater than 2.0 inches (50 mm) from the base of the ink tank, it is time to replace the ink tank. The ink
tank must be replaced because fine dirt, dust, and other foreign material causes the ink tank’s filter to
malfunction. The ink tank replacement interval depends on the usage environment and conditions.
Contact Epson Support for information on replacing components.
Note:
Your product has a remaining ink warning system. This system does not directly detect the
amount of ink remaining in the ink tank. Instead, the amount of ink remaining is estimated based on the
ink usage conditions and displayed as a message. The accuracy of this system depends on consistent
and proper ink refills.
If the procedure for replacement and ink refilling here is not followed correctly, the remaining ink warning
system may not function properly. To prevent this, replace the chip unit and refill the ink as soon as
possible once the remaining ink level falls below 2.0 inches (50 mm) from the base of the ink tank.
Parent topic:
Replacing the Ink and Chip Unit
Related tasks
Replacing the Chip Unit and Refilling Ink
Ink and Chip Unit Precautions
Follow these precautions as you refill the ink in your product:
• Store ink packs in a location out of the reach of children.
• Wear protective eyewear and gloves when refilling ink.
• Be sure to read the Safety Data Sheet (SDS) before using ink packs. To download it, visit
(U.S.) or
(Canada) and select your product.
• Gently cut or tear off the ink pack spout seal. If you cut the ink pack spout seal too quickly, ink may
splatter.
• Do not squeeze open ink packs. Ink may spill.
• Gently tilt the ink pack when pouring ink into the ink tank.
Summary of Contents for SureColor F9470
