Epson Stylus Photo R3000 Series, Service Manual

Page: 63 / 73

Confidential
Adjustment Details of Adjustments (TBD) 63
Epson Stylus Photo R3000 Revision A
11. Click [Next], and write the Color ID to the printer. After the writing has finished, the Colorimetric
Calibration Tool automatically checks the Color ID.
Figure 2-35. Writing of Color ID
12. When the following screen is displayed, click [End], and turn the printer OFF then back ON again to
complete the adjustment. This action reflects the color measurement values on the printer.
Figure 2-36. END
 Be sure to start the measurement from the top side of the chart.
 Be sure to measure colors at each row two times.
 During color measurement, do not allow the calibrator to rub against unmeasured
patches on the chart.
 Prevent the ruler and calibrator from coming off the chart sheet during color
measurement. Doing so will cause incorrect color measurement.
 During color measurement, measure only the patches on the chart sheet. Do not measure
other parts such as the USB ID text string.
 When there is an error possibility in measuring color, a warning mark ( ) appears at
the patch in question. In such case, make sure to measure the row that includes the patch
with a warning mark again. If the same warning mark appears again at the same point,
ignore the marking and perform the measurement in the next line.
 If the number of scanned patches does not match the number of patches on a single row,
the cursor stops at that row, the error mark (
) appears on all of the patches on that
row, and the following error message is displayed:
• “Color measuring by Eye-One calibrator has failed. Measure colors of the failed row
again.”