Epson SC-T3000, Service Manual

Page: 144 / 314

SC-T7000 series/SC-T5000 series/SC-T3000 series Revision B
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 144
Confidential
3.4.4.11 APG UNIT
1. Remove the UPPER LEFT COVER. (p100)
2. Remove the UPPER SUPPORT R COVER. (p94)
3. Remove the PANEL BOARD. (p120)
4. Remove the TOP COVER. (p85)
5. Remove the RIGHT UPPER COVER & RIGHT ROLL COVER. (p95)
6. Remove the RIGHT LOWER COVER. (p96)
7. Remove the five screws, and remove the R Reinforce Plate.
A) Silver M3x6 S-tite screw with built-in washer: 3 pcs
B) Silver M3x8 S-tite screw with built-in washer: 2 pcs
Figure 3-90. Removing the R Reinforce Plate
A D J U S T M E N T
R E Q U I R E D
When replacing/removing this part, refer to “4.1.2 Adjustment
Items and the Order by Repaired Part” (p199) and make sure to
perform the specified operations including required adjustment.
C A U T I O N
When removing the R Reinforce Plate in the next step, take care
not to remove the Upper Reinforce Plate together.
Pay attention to the positioning point (See Figure 3-90 ).
B
APG UNIT
R Reinforce Plate
A
A
B
Rear Tube Guide
A
Upper Reinforce Plate
Positioning point