Epson LabelWorks Printable Ribbon Kit, User Manual

Page: 27 / 40

Solving Problems | 25
Solving Problems
If you have a problem with your LabelWorks,
check the display or the troubleshooting
suggestions below.
Error messages
Insert tape Turn the power off and install a
tape cartridge.
Check battery The batteries may be running out
or installed incorrectly, non-
alkaline batteries are being used
with alkaline batteries, or old and
new batteries are being used
together. Turn the power off and
replace batteries with new ones,
or use the optional AC adapter.
Make sure new batteries are
installed correctly.
Too many lines You have exceeded the maximum
number of lines (2). Press
to
delete the lines indicated.
Seq. num. only 1 Sequence numbers have already
been set. You can only enter one
sequence number per ribbon.
Txt too long-OK? Entered text is too long for the
specified ribbon length. Press
and adjust the ribbon length
or make text shorter.
Overheated! The print head is too hot. Turn the
power off and take out the tape
cartridge. Allow the print head to
cool before trying to print again.
Cover open! If you open the rear cover while
the power is on, this message
displays and the power turns off
automatically. Always turn the
power off before opening the rear
cover.
Delete all text? When creating a ribbon with a
special format, the current text
will be deleted. Press
to
delete the text and show the
special format.
Motor error! An error occurred in the motor
operation. Turn the power off,
then turn it back on. If the same
message appears, turn the power
off again and contact Epson for
technical support.