Epson C823781, Administrator'S Manual

Page: 44 / 258

32 How to Set Up the Print Server
Note:
❏
Use a Category 5 twisted-pair cable to connect the print server
to the network.
❏
The print server will automatically use DHCP to obtain an IP
address. If it cannot get an IP address this way, it will use the
private IP address of 192.168.192.168.
❏
Do not connect the print server and the computer directly. Be
sure to use a hub to connect the print server to the network.
4. Turn the printer on.
5. Plug the AC adapter’s power cord into a grounded electrical
outlet. Then connect it to the AC adapter. Be sure to use the
AC adapter included with the print server.
6. Press and hold down the status sheet button on the print
server, then plug the AC adapter into the DC-IN connector on
the print server. Continue to hold down the status sheet
button for about ten seconds.
Note:
It can take up to one minute to initialize the print server. When it’s done
initializing, its
STATUS light turns green or orange.
7. When the print server is done initializing, press the status
sheet button again for about two seconds to print the status
sheets. If the sheets print, the print server is installed correctly.
c
Caution:
❏
Do not press the status sheet button while the red Status light
and green Data light are on; otherwise, the print server will
return to its factory default settings, and the network status
sheet will not print correctly.
❏
Before disconnecting the print server from the printer, always
turn off the printer and unplug the AC adapter.