Epson C82314*, User Manual

Page: 8 / 71

BUTTON SPECIFICATIONS
Button
Top
Bottom
Both
Functions
PA1 response when the PA red LED is on
Prints out a page listing when pressed and held for 2 seconds. If the
coax cable is disconnected, then a RAM/ROM self test is also
performed and the results are printed.
YES response during push button setup (see Appendix B)
PA2 response when the PA red LED is on
Begins restoration of factory default setup (see “Restoring Factory
Default Configuration’ section)
NO response during push button setup (see Appendix B)
After turning on, if both buttons are pressed and released (for less
than one second) a cancel signal is sent to the host. The red LED
will blink twice times to confirm the cancel signal was sent. (Note:
The printer will continue printing until its buffer is empty.)
After turning on, if both buttons are pressed and held more than two
seconds, the interface enters the hexadecimal (buffer dump)
diagnostic printing mode. The printer then prints “Buffer print is
active’ and the green LED will blink twice. Turn off the printer to exit
this mode or press and hold both buttons for more than two seconds
which will cause the green LED to blink twice. (Also, see Command
42 in Appendix A for a download command.)
I N S T A L L A T I O N
CONTENTS OF INTERFACE KIT
Make sure the interface kit includes all items listed below:
Coax interface card
PC Auto Parallel Sharing Cable
User’s guide