Epson AcuLaser C1900, Service Manual

Page: 215 / 270

EPSON AcuLaser C1900/AcuLaser C900 Revision B
Adjustment Service Utility (AcuLaser C900) 215
5.3.2.2 Functions
This service utility can execute the following functions:
†
“Printer” information
„
Name of the printer connected (“AcuLaser C900”)
„
“Communication Mode” information
Displays the interface connected
•
Nibble (parallel interface)
•
ECP (parallel interface)
•
USB
•
I/F Card (Type-B / Network I/F)
„
“Printer Firmware” information
Firmware version currently installed
„
“Engine Firmware” information
Mechanical controller firmware version currently installed
†
“Engine Status Sheet”
Prints the engine status sheet.
†
“Reset Counter”
Initializes the counters for the Regularly Replaced Part and After-Sales Service
Parts whose lives are controlled by the printer. The parts for which the counter
must be initialized are as follows:
„
“Fuser” (Main Fuser Assembly: Regularly Replaced Part)
†
“USB ID”
Registers the ID number for the USB interface in EEPROM on the Main Board.
5.3.3 Operation
5.3.3.1 Engine Status Sheet
Click the [Status Sheet] button to print the engine status sheet.
When the engine status sheet is being printed, the process control (Cycle Up / Cycle
Down process control) of the engine will be forcedly carried out.
5.3.3.2 Reset Counter
When you have replaced any of the Regularly Replaced Part and After-Sales Service
Parts specified
above , be sure to reset the relevant counter.
C H E C K
P O I N T
Since the paper size supported is only A4, set A4 size paper in the
printer.
C H E C K
P O I N T
Once you have executed resetting, you can never undo the
resetting. To warn you not to execute resetting carelessly, the
confirmation screen as shown below will be displayed when the
[Execute] button for Reset Counter has been clicked. Click [OK]
to execute initializing the counter or click [Cancel] to terminate
the service utility without executing resetting.