Epson 8300NL - PowerLite XGA LCD Projector, User Manual

Page: 77 / 138

Managing the Projector from a Remote Computer
77
5. If your network does not assign addresses automatically, turn off
DHCP
and enter the projector’s
IP Address
,
Subnet Mask
, and
Gateway Address
, as needed.
■
To enter numbers using the remote control, press the
Num
button until it lights, then use the number keypad shown
below.
■
To change the network addresses from the projector’s control
panel, press the right and left arrow buttons to select the part
of the address you want to enter, then use the up and down
arrow buttons to increase or decrease the numeric value.
When you finish changing an address in the network menu, press
the
Enter
button (on the remote control) or the
Auto/Enter
button (on the projector). This stores the value.
6. When done making all necessary changes, press
E
SC
to exit the
menu system.
note
If you’re a network
administrator, you can use
the
SNMP
option to enter a
trap IP address. This lets you
monitor the projector using
a network management
utility.
0
Num button
Zero
Increase
or
decrease
the value
Select the
part of the
address to
change