Epiroc RD 100, Safety And Operating Instructions Manual

Page: 23 / 32

Safety and operating instructions
© Construction Tools PC AB | 98001365 01 | 2020-09-24
Original Instructions
23
7.3 Replace the drill steel
bushings
The bushings must be replaced if they show signs of
wear.
1. Remove the Drill steel Gaiter by hand.
2. Use the Epiroc wear gauge to remove the outer
bushing (A). Insert the wear gauge teeth end aligned
with the bushings corners. Push it in half way. Slightly
twist the tool so it grabs the flat area behind the outer
bushing were it will get best grip. Use a screw driver
as a handle and pull the bushing out.
A
B
C
3. Insert the wear gauge in one of the bushings corners
and push it in against the anvil so the hook grabs at
the inner edge of the bushing. Slightly twist the tool
so it grabs the flat area were it will get best grip. Use
a screw driver as a handle and pull the inner bushing
and seal out.
4. Replace the worn components. The seal must always
be replaced.
5. Start by inserting and positioning the inner bushing
(C) completely. When the inner bushing is correctly
seated continue to position the seal and outer bush-