Installation and Getting Started
Windows video capture workstation Installation
Installation Guide
Page 11
To start the Windows capture application
1
Start the capture application.
Depending on your installation you could select
Start >
VGA2USB
or
Start > Epiphan VGA2Ethernet >
VGA2Ethernet GUI
.
The capture application starts up.
If the Frame Grabber is connected and powered on, the
capture application should automatically find it and begin
displaying captured images (see
If the Frame Grabber is operating but not capturing images the
device name and serial number should appear in the title bar
and the capture application displays
No signal detected
. The
status bar should display the IP address of a Network Frame
Grabber.
If the capture application displays
Capture device not found
the capture application cannot find the Frame Grabber.
If you have added a viewer password to a Network Frame
Grabber, you will be prompted to enter the password before
the image being captured by the device appears in the capture
window.
2
You can select
Capture > Select Device
to view the Frame
Grabber devices that the capture application has found.
If you have more than one Frame Grabber, you can select the
one to connect the capture application to from this list.
3
If you have a Network Frame Grabber you can also select
Capture > Connect Network Device
to select or enter the IP
address of a Network Frame Grabber to connect to.
“Troubleshooting a Windows installation” on page 41
information about troubleshooting the installation.
