Standalone VGA Grid User Guide
AFU using CIFS
3. Specify the
Server module
. This is the name of the shared folder on the server. If needed, request this
value from your network administrator.
4. Specify a username for the RSync Server in the
Login
field. The user must have write permissions for
the module.
5. Specify the password for the user in the
Password
field; the value is masked by dots.
6. If desired, select the
Checksum
check box to add a checksum validation to the transfer between the
system and the recipient server.
7. Click
Apply
; if there are any problems the system notifies you with a message: One or more parameter
values are not valid and those were not applied!
The following table describes the options applicable to configuring upload to an RSync server.
Table 25
RSync Automatic File Upload Configuration Options
Name
Description / Options
Server
address
The IP address (or fully qualified domain name) of the RSync server.
Server module The name of the shared folder on the RSync server.
Login
Username for the RSync server.
Password
Password for the RSync user.
Checksum
Select to enable checksum checking during file transfer. This increases the time taken to
transfer, but also increases reliability of the transfer.
AFU using CIFS
This procedure assumes you have completed the steps in
and wish to continue
with configuration of upload using CIFS (also known as SMB or samba).
To configure upload using CIFS:
1. Select
CIFS Client
from the protocol drop down list in the Automatic File Upload configuration page;
the lower half of the page reflects the selection.
229
