Epever TRIRON N Series, User Manual

Page: 39 / 60

33
Ⅳ
. Under Voltage Warning Reconnect Voltage > Under Voltage Warning Voltage
≥ Discharging Limit Voltage.
Ⅴ
. Boost Reconnect Charging voltage > Low Voltage Disconnect Voltage.

The following rules must be observed when modifying the parameters value in
User for lithium battery.
Ⅰ
. Over Voltage Disconnect Voltage>Over charging protection
voltage(Protection Circuit Modules(PCM))+0.2V
※
；
Ⅱ
. Over Voltage Disconnect Voltage>Over Voltage Reconnect Voltage
＝
Charging Limit Voltage
≥ Equalize Charging Voltage ＝
Boost Charging Voltage
≥ Float Charging Voltage>Boost Reconnect Charging Voltage ；
Ⅲ
. Low Voltage Reconnect Voltage>Low Voltage Disconnect Voltage
≥
Discharging Limit Voltage
；
Ⅳ
. Under Voltage Warning Reconnect Voltage>Under Voltage Warning Voltage
≥
Discharging Limit Voltage
；
Ⅴ
. Boost Reconnect Charging voltage>Low Voltage Disconnect Voltage.
；
Ⅵ
. Low Voltage Disconnect Voltage
≥ Over discharging protection voltage
(PCM)+0.2V
※
；
WARNING: The required accuracy of PCM shall be at least 0.2V. If
the deviation is higher than 0.2V, the manufacturer will assume no
liability for any system malfunction caused by this. .
5.2 Load working modes
5.2.1 LCD setting
1
）
DS1 module display and operation
Operation:
Step1: Press the button and hold 5s for the load mode interface.
Step2: Press the button when the load mode interface is flashing.
Step3: Press the button to confirm the load working modes.