Epever TRIRON N Series, User Manual

Page: 21 / 60

15
Step 4
：
Connect accessories

Connect the remote temperature sensor cable (model: RTS300R47K3.81A)
Connect one end of the remote temperature sensor cable
to the interface
③
and place the other end close to the battery.
NOTE: If the remote temperature sensor is not connected to the controller,,
the default setting for battery charging or discharging temperature is 25 °C
without temperature compensation.

Connect the accessories for RS485 communication
Refer to
3.2 “Setting and Operation of Controller”
NOTE: The RS-485 port is not SELV circuit, it must have isolation
between the port and the place where the end user can access directly.
Step 5
：
Powered on the controller
Closing the battery fuse will switch on the controller. Then check the status of the
battery indicator (the controller is operating normally when the indicator is lit in green).
Close the fuse and circuit breaker of the load and PV array. Then the system will be
operating in the preprogrammed mode.
NOTE: If the controller is not operating properly or the battery indicator on
the controller shows an abnormality, please refer to 4.2 “Troubleshooting”.