5)
Flip over Frames and connect the shared legs of the Spine Wall (main run) with 10-24x2” screws
(UZBOLTU) and 10-24 weld nuts (UZWNUTA). Note: if using “T” legs Grid Frames will stand up
on their own. If using straight legs, a helper, chairs or walls must be used to hold up the table
during this step.
NOTE: IF YOU HAVE MODESTY PANELS IT IS BEST TO INSTALL BEFORE ATTACHING ALL
GRID FRAMES TOGETHER. GO TO MODESTY PANEL INSTALL toward the back of these
instructions.
6) Top Caps must be removed by taking out the 4 - #8-32x3/4” Flat head screws(UZSCREWAL) on
the top of each Grid Frame using a #15 Torque head drive. (Leave Top Caps off until step #24).
7) Attach in-line panel to panel connections using 10-24 screw (UZSCREWW) and 10-24 lock nut
(UZWNUTB) through aligned holes at the top of the End Caps.
8) If the Spine wall does not have any 90 Degree or 120 Degree Grid Fin walls, go to Line#16.
9)
If you are beginning a 90 or 120 Degree Fin Wall connection, refer to lines 1 & 2 above to sub-
assemble Frames First.
10)
For 120 Degree connections go to line #14
.
11) The 90 Degree Fin wall will be attached to the Spine Wall using the UC90 Connector kit (UPP90
kit if power runs down Fin wall) in the orientation below:
