BURNER FLAME APPEARANCE AND ADJUSTMENT
TO ADJUST MAIN BURNERS FOR PROPER FLAME APPEARANCE:
Remove the cooking grates from the Gas Grill.
Remove the flame deflectors located below the cooking grates.
Remove the burner tube. Undo one screw and the mounting plate on the rear of the gas grill and lift burner tube
out.
Loosen the single set-screw that holds the venturi air shutter adjustment on the burner tube.
If the flame was too yellow and lazy in appearance then open the air shutter until a soft blue flame is achieved.
This flame should also stay on the burner tube as shown above.
If the flame is lifting off the burner tube and the flame sounds like a blow torch this could be that there is to much
air being supplied, undo the set screw and close the air shutter until a soft blue flame is achieved.
Undo the set-screw and rotate the
venturi cover until a soft blue
flame is achieved
SOFT BLUE FLAMES
Normal: Flames soft, and
staying on burner tube
HARD LIFTING BLUE
FLAMES:
Too much air, Close air shutter
LAZY YELLOW FLAMES:
Not enough Air, Open air shutter
15
