The
ENVIROGRILL BISTRO
is operated with an electronic battery operated ignition system.
If at any time when lighting the gas grill a sparking sound is not heard it could be that the battery requires
replacing.
Battery
If the battery has been replaced and spark is still not present insure to check all
wiring and spark electrode for breakage or corrosion. (See trouble shooting
section in this manual)
BATTERY REMOVAL
To remove the battery, unscrew the igniter button located on the control panel
front. Remove igniter button and pull spring out igniter body, the “AA” will come
out with the spring attached.
Replace the battery
and install in the
reverse order.
IGNITER MODULE REMOVAL
To remove the igniter module from under the control
panel. First remove the two 1/4“ x #8 stainless steel
sheet metal screws and drop the module and the heat
shield straight down (as shown). Remove one of the
short wires that comes from ignition module that is
connected to ground, install any new wires were the
short wire was removed from the ignition module for
the extra components that could be added to the
ENVIROGRILL BISTRO.
NOTE:
When installing the igniter module and the heat
shield please take special care not to damage any of
the wires as failure in the ignition system could
occur.
Unscrew igniter button
and remove battery.
Undo the 2 two 1/4” x #8 sheet metal screws and
drop igniter module straight down
+
-
2
3
4
Main burner wires to
spark electrodes
Main wires to spark button
mounted on control panel
Ground wire, spark electrode wire to rear
burner
Ground wire
Ground
SIDE BURNER
WIRING
11
