ROUTINE MAINTENANCE AND INSPECTION
HOSE ASSEMBLY AND SAFETY:
If the hose shows signs of deterioration or damage, use a soap and water solution and test the entire outer
surface of the hose while under pressure. Replace at the first sign of a leak or if age cracking becomes
apparent. Remember to turn the gas supply off before disconnecting. The hose must remain free of kinks and
sharp bends. Never puncture or put stress on the hose fittings. Replace the hose only with the manufactures
original equipment.
BURNERS:
The location of the burners to the main orifice is vital for safe operation. Check to assure the valve orifices are
inside the burner tubes before using the gas grill. If venturi of the burner is not correctly positioned over the
valve orifices, explosion and or fire may occur when lighting the gas grill. Be careful not to damage the ceramic
spark electrodes.
ENSURE THAT THE
BURNER TUBE
FITS OVER VALVE
ORIFICE
BURNER CLEANING:
To keep you’re
ENVIROGRILL BISTRO
working correctly the burners should be checked and cleaned on a regular
basis. To clean the burner tubes first remove the burner tubes from the barbecue. Bend a stiff wire (coat hanger)
and run the hooked end up through each venturi tube and into the burner several times. Turn the burner upside
down and force water from the garden hose into the burner. Observe the water flow from the holes in the burner
to make sure all holes have water coming out. If not, continue to clean the burner by cleaning each individual
obstructed hole. Wire brush the outside of the burner to remove any loose corrosion. Clean any holes with a stiff
wire. If the burner has holes other than the holes from the factory replace the burner with the manufacturers
original part. A clogged burner tube could cause a fire beneath the gas grill.
To remove the burners from the unit, first
remove the cooking grids and the flame
deflectors to access the burners. Undo the
1/4” hex head bolt located on the rear of the
inside liner. Lift the back of the burner up
slightly and remove from the appliance.
Install the burner in the reverse order and
ensure that the burner is placed over the
orifice.
(SEE DIAGRAM BESIDE)
Undo the one screw
and slide the burner
back and lift out of
appliance
4
