
7
8
Special Functions for Buttons
UP button:
In monitoring mode, it is used to display the maximum voltage value.
In program mode, it is used to change the device parameters.
SET button:
When it is pressed for 3 seconds, the user enters MAIN MENU. It is then used to
enter SUB MENUs from the MAIN MENU and to save the changes in parameters.
If Latch function is active, it opens the alarm output contacts when the system
voltage leaves the programmed range. When the voltage enters the programmed
range, alarm output contacts dont close (lock-hold). Output contacts are closed
by using the SET button.
DOWN button:
In monitoring mode, it is used to display the minimum voltage value.
In program mode, it is used to change the device parameters.
1.4 HARDWARE FEATURES
- Voltage measurement connector (2-pin, V+, V-)
- 0/2-10V, 0-4/20 mA Analog Output connector (3-pin, V, GND, I)(DCV-10A/11A)
- RS-485 connector (4-Pin)(DCV-10S/10CS/11S/11CS)
- 2 Relay connectors ( 4-pin)(DCV-10C/10CS/11C/11CS)
- Supply input (2-pin) (85-265V AC/DC (DCV-10/10A/10C/10S/10CS),
10-56V DC (DCV-11/11A/11C/11S/11CS))
2- USAGE OF DEVICE:
2.1 MENU USAGE AND SETTINGS:
After the device is installed according to the connection diagram in the user manual, energise the
device.(Refer to: Connection diagram)
In order for the measurements and applications to be accurate, necessary adjustments must be made
by using menus.
2.2 MAIN MENUS:
There are 10 main menus on the device for measurement and usage settings. The user can access
MAIN MENUs by pressing the SET button for 3 seconds on measurement screen. By pressing the SET
button on any MAIN MENU, SUB MENUs of the related MAIN MENU is entered.
Note:
In order for a change that you committed in the menu to be in effect, you must give approval
for those changes when exiting the menu. Otherwise, changes will not be in effect.