
2
1
Displayed
only when
limit is
crossed in
opposite
direction.
Read the user manual completely before using the device.
The box is under dangerous high voltage. The device must be installed and serviced only by
a qualified service personnel.
Is not displayed when
limit is crossed in
opposite direction.
If a voltage higher than 200V or lower than -200V is applied to the measuring
input of the device, a warning is displayed like the one on the left.
H VOLTGE
Warnings
- Connect a button or a circuit breaker between the grid and the supply inputs of the device.
- This button or circuit breaker must be in close proximity of the device.
- This button or circuit breaker must be marked to indicate that it is used to separate the device from
the grid.
Standards That Are Applied To The Device
EN 61010-1, EN 60255-5, EN 60255-22-5, EN 60255-22-4, EN 60255-22-2, EN 60255-11, EN 60255-22-3
Guarantee
The device has a 2 year guarantee. In case of a malfunction, repairs of the device must be done only by
the authorised technical service or the guarantee will be void.
1. INTRODUCTION............................................................................................1
1.1. APPLICATIONS..................................................................4
1.2. GENERAL FEATURES...........................................................4
1.3. FRONT PANEL.....................................................................5
1.4. HARDWARE FEATURES......................................................7
2. USAGE OF DEVICE......................................................................8
2.1. MENU USAGE AND SETTINGS..........................................8
2.2. MAIN MENUS.....................................................................8
2.2.1. PERIOD SETTING MENU............................................10
2.2.2. ALARMS MENU............................................................10
2.2.3. ANALOG OUTPUT SETTING MENU.............................18
2.2.4. RS-485 SERIAL COMMUNICATION SETTING MENU...20
Index
ATTENTION
- Disconnect all power before connecting the device.
- Dont remove the front panel while the device is connected to the network.
- Dont clean the device with solvent or similar substances. Only clean with a dry cloth.
- Verify correct terminal connections when wiring.
- Electrical devices should be serviced only by your component seller.
- Device is for rack panel mounting only.
- Fuse which will be used must be F type and its current limit value must be 1A.
- No responsibility is assured by the manufacturer or any of its subsidiaries for any problems
arising out of the disregard of these conditions.
SECURITY