Removing and Reinstalling the Fan Tray
3-10
5C105 Setup
3.3
REMOVING AND REINSTALLING THE FAN TRAY
The 5C105 is equipped at the factory with a removable fan tray that allows for easy periodic
cleaning and/or replacement if a problem occurs with fan operation. A flat blade screwdriver is
needed to remove and reinstall the fan tray. To remove and reinstall the fan tray in the 5C105, refer
to
Section 3.3.1
and
Section 3.3.2
.
3.3.1
Removing the Fan Tray
To remove the fan tray, refer to
Figure 3-6
and proceed as follows:
1. Locate the ESD wrist strap shipped with the 5C105. Attach the ESD wrist strap to your wrist
and plug the cable from the ESD wrist strap into the ESD grounding receptacle at the upper right
corner of the 5C105.
2. Use a screwdriver to loosen the slotted screws located on either side of the fan tray.
3. Slowly slide the fan tray out of its slot in the bottom of the chassis.
CAUTION: The fan tray is hot swappable; however, the chassis must not be run without
the fan tray for extended periods of time, as it will quickly overheat.